A trim fan attached to a slitter. As discussed previously on this blog the process of slitting (at its most basic) can be reduced to the one-line description of ' a big roll is loaded on one side of the slitter rewinder, and smaller rolls are loaded off the other side' and that's fine... most of the time. Here comes the example! If a 1000mm wide roll is loaded onto a rewinder and is slit down into rolls that are 212mm wide then four rolls would be produced. If your mental maths is up to scratch you might have noticed that 4x212 does not equal 1000, and that means that from the original / master / jumbo roll there will be roughly 117mm left over. Sometimes this happens because the edges of jumbo rolls are discarded due to damage, print reasons or simply because the material being slit isn't coated all the way to the edges of the roll. So what happens to this waste material? Waste material can be wound onto cores in the same way 'correct' rolls are, ...
Comments
Post a Comment